It was a pretty quiet weekend here, but I’m still trying to get warm-weather things done before the cold weather hits. I did some work on the door cards I got up in Massachussetts to get them ready for paint. They were covered in about three inches of grease and dirt, so I played a hunch and used Easy-Off oven cleaner to clean them off. When I had all the crud removed I could see where the rust lived. Originally I was going to sandblast them but I figured that would take forever, so I just used the wire wheel to remove all of the bad stuff. Meanwhile I covered the back sides with Rust Converter to keep them clean.

Friday afternoon I went to the local Sherwin Williams Automotive and had them match and mix a quart of base color from the beat-up original door panel on the truck. I had them match from the area behind the door escutcheon, which hadn’t been dulled by UV rays over 60 years. After some back and forth I used some of their paint matching chips to get as close as possible in the sunlight out in front of the store. The best price I could get was on a quart of base coat in satin, which is going to need a final clearcoat at some point in the future. But the difference being roughly $200, I was happy to go with the more inexpensive option.

On Sunday morning, I cleaned everything off with acetone and got my table ready to shoot everything. All four panels needed two light coats for good coverage—the base was a lot thinner than the other paint I’ve been shooting.

Then I shot the heater box and heater cover. Everything flashed very quickly and within two hours was more than dry to the touch.

I hung all four-door cards on the truck to keep them out of the way and make sure they didn’t get scratched up in the garage.

Meanwhile, I was working on new mounts for the west coast mirrors. What I decided was to mount these using existing holes in the doors. There were, over time, about four different mirror installations on the truck, one of them being perfect for the mirrors I have. I bought four regular steel bolts and pushed them through the back sides of the doors to weld in place. Then I ground the backsides down as much as possible to give clearance for the weatherstripping and doors.

The passenger side still needed to be worked on: all the old holes had to be ground out and welded over like I did on the driver’s side. Then I cleaned those up, feathered some filler over them, and sanded it smooth. As of Sunday evening, both mirrors are hung on each door with a quick coat of basic rattle can red over everything.

The Sherwin Williams guy told me about some inexpensive clear coat I could get on Amazon much cheaper than in his store, so I’ve got that in my cart for next weekend. It’s a satin finish so it won’t be as dull as the original cards, but if it protects everything I’m not going to complain. And when the heater box is finished, I can reinstall that and get more of the stuff under the dash completed, which is one of the fall projects on my list.

→ This is a syndicated post from my Scout weblog. More info here.

Date posted: September 9, 2024 | Filed under Scout, Travelall | Leave a Comment »

Leave a Reply

Your email address will not be published. Required fields are marked *